DES-3000 Series Layer 2 Switch CLI Reference Manual
config traffic_segmentation
Purpose Used to configure traffic segmentation on the Switch.
Syntax
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
Description
The config traffic_segmentation command is used to configure
traffic segmentation on the Switch.
Parameters
<portlist> − Specifies a port or range of ports to be configured for
traffic segmentation.
forward_list − Specifies a port or range of ports that will receive
forwarded frames from the ports specified in the portlist, above.
• null − No ports are specified
• <portlist> − Specifies a range of ports for the forwarding list.
This list must be on the same switch previously specified
for traffic segmentation (i.e. following the <portlist>
specified above for config traffic_segmentation).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3026:4#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3026:4#
114
To Next Page
Loading...
