DES-3000 Series Layer 2 Switch CLI Reference Manual
config 802.1x auth_parameter ports
Purpose Used to configure the 802.1x Authentication parameters on a range of
ports. The default parameter will return all ports in the specified range to
their default 802.1x settings.
Syntax
config 802.1x auth_parameter ports [<portlist> | all] [default |
{direction [both | in] | port_control [force_unauth | auto | force_auth] |
quiet_period <sec 0-65535> | tx_period <sec 1-65535> | supp_timeout
<sec 1-65535> | server_timeout <sec 1-65535> | max_req <value 1-10>
| reauth_period <sec 1-65535> | enable_reauth [enable | disable]}]
Description
The config 802.1x auth_parameter command is used to configure the
802.1x Authentication parameters on a range of ports. The default
parameter will return all ports in the specified range to their default 802.1x
settings.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
max_req <value 1-10> − Configures the number of times to retry sending
packets to a supplicant (user).
enable_reauth [enable | disable] − Determines whether or not the Switch
will re-authenticate. Enabled causes re-authentication of users at the time
interval specified in the Re-authentication Period field, above.
default − Returns all of the ports in the specified range to their 802.1x
default settings.
direction [both | in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or just the
receiving direction.
port_control − Configures the administrative control over the authentication
process for the range of ports.
quiet_period <sec 0-65535> − Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response from a
supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a response
from a supplicant (user) for all EAP packets, except for the Request/Identity
packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for a
response from a RADIUS server.
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
Restrictions
force_auth − Forces the Authenticator for the port to become
authorized. Network access is allowed.
auto − Allows the port’s status to reflect the outcome of the
authentication process.
force_unauth − Forces the Authenticator for the port to become
unauthorized. Network access will be blocked.
Only administrator-level users can issue this command.
171
To Next Page
Loading...
