D-Link DES-3026 - Switch - 19 IGMP SNOOPING COMMANDS

DES-3000 Series Layer 2 Switch CLI Reference Manual
19
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config igmp_snooping [vlan_name <vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer
<sec 1-16711450> | state [enable | disable] | fast_leave [enable |
disable]}
config igmp_snooping
querier
[vlan_name <vlan_name 32> | all] {query_interval <sec 1-
65535>| max_response_time <sec 1-25> robustness_variable
<value 1-255> | last_member_query_interval <sec 1-25> | state
[enable | disable]
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
disable igmp snooping
show igmp snooping {vlan <vlan_name 32>}
show igmp snooping group {vlan <vlan_name 32>}
show router_ports {vlan <vlan_name 32>} {[static | dynamic]}
config router_ports
enable igmp snooping
Each command is listed, in detail, in the following sections.
142