D-Link DES-3026 - Switch - 10 SPANNING TREE COMMANDS

DES-3000 Series Layer 2 Switch CLI Reference Manual
10
SPANNING TREE COMMANDS
The Switch supports 802.1d STP and 802.1w Rapid STP. The spanning tree commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following table.
Command Parameters
config stp {maxage <value 6-40> | hellotime <value 1-10> | forwarddelay
<value 4-30> | priority <value 0-61440> | version [rstp | stp] |
txholdcount <value 1-10> | fbpdu [enabled | disabled] | lbd [enabled
| disabled] | lbd_recover_timer [0 | <sec 60-1000000]}
config stp ports <portlist> {cost [auto | <value 1-200000000>] | priority <value 0-
240> | migrate [yes | no] | edge [true | false] | p2p [true | false |
auto] | state [enabled | disabled] | lbd [enabled | disabled] |
fbpdu [enabled | disabled] }
enable stp
disable stp
show stp
show stp ports {<portlist>}
Each command is listed, in detail, in the following sections.
74