DES-3000 Series Layer 2 Switch CLI Reference Manual
config lacp_ports
Purpose
Used to configure settings for LACP compliant ports.
Syntax
config lacp_ports <portlist> mode [active | passiv
e]
Description
This command is used to configure ports that have been
previously designated as LACP ports (see create
link_aggregation).
Parameters
<portlist> − Specifies a range of ports to be configured for LACP.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices
must support LACP.
passive – LACP ports that are designated as passive
cannot process LACP control frames. In order to allow the
linked port group to negotiate adjustments and make
changes dynamically, at one end of the connection must
have “active” LACP ports (see above).
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
DES-3026:4#config lacp_port 1-6 mode active
Command: config lacp_port 1-6 mode active
Success.
DES-3026:4#
127
To Next Page
Loading...
