DES-3000 Series Layer 2 Switch CLI Reference Manual
Example usage:
To view the current CoS mapping for static MAC addresses:
DES-3026:4#show cos mac_mapping
Command: show cos mac_mapping
MAC Address Class
------------------------------
01-00-D6-E4-FF-05 3
DES-3026:4#
config cos tos value
Purpose Used to map the Type of Service (ToS) value in the IP header of incoming packets to one
of the four hardware queues available on the switch.
Syntax
config cos tos value <value 0-7> [class <class_id 0-3>]
Description Use this command to map ToS priority value in the IP header of an incoming packet to
one of the hardware queues on the Switch.
Parameters <value 0-7> - Specifies the ToS value in the IP header to be mapped.
class <class_id 0-3> - Specify the hardware queue to which the ToS value is mapped.
Restrictions
Example usage:
To map a ToS priority value 3 to a hardware queue 2 for incoming packets with ToS information:
DES-3026:4#config cos tos value 3 class 2
Command: config cos tos value 3 class 2
Success
DES-3026:4#
111
To Next Page
Loading...
