DES-3000 Series Layer 2 Switch CLI Reference Manual
config address_binding ip_mac ports
Purpose Used to enable ports on the Switch to be configured for IP-MAC
address binding.
Syntax
config address_binding ip_mac ports [<portlist> | all] state
[enable | disable]
Description This command will configure ports as enabled or disabled for the
IP-MAC address binding function.
Parameters
<portlist> − Specifies a port or range of ports to be enabled or
disabled for IP-MAC address binding.
all – Specifies all ports on the Switch are to be enabled or disabled
for IP-MAC address binding.
State - [enable | disable] – Enables or disables the specified range
of ports for IP-MAC address binding.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure port 2 to be enabled for IP-MAC address bindings:
DES-3026:4#config address_binding ip_mac ports 2 state enable
Command: config address_binding ip_mac ports 2 state enable
Success.
DES-3026:4#
134
To Next Page
Loading...
