DES-3000 Series Layer 2 Switch CLI Reference Manual
disable smtp
Purpose Used to disable the Switch as a SMTP client.
Syntax
disable smtp
Description
This command, in conjunction with the enable smtp command
will enable and disable the Switch as a SMTP client without
changing configurations.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable SMTP on the Switch.
DES-3026:4#disable smtp
Command: disable smtp
Success.
DES-3026:4#
config smtp
Purpose Used to configure necessary information in setting up the Switch
as an SMTP client.
Syntax
config smtp {server <ipaddr> | server_port <tcp_port_number
1-65535> | self_mail_addr <mail_addr 64> | [add mail_receiver
<mail_addr 64> | delete mail_receiver <index 1-8>]}
Description This command will allow the user to set the necessary parameters
to configure the SMTP server and mail recipients. This command
must be completely configured properly for the SMTP function of
the switch to correctly operate.
Parameters server <ipaddr> - Enter the IP address of the SMTP server on a
remote device.
server_port <tcp_port_number 1-65535> - Enter the virtual port
number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25.
self_mail_addr <mail addr 64>- Enter the e-mail address from
which mail messages will be sent. This address will be the from
address on the e-mail message sent to a recipient. Only one self
mail address can be configured for this Switch. This string can be
no more that 64 alphanumeric characters.
add mail_receiver <mail_addr 64> - Choose this parameter to add
mail recipients to receive e-mail messages from the Switch. Up to
8 e-mail addresses can be added per Switch.
delete mail_receiver <index 1-8> - Choose this parameter to
delete mail recipients from the configured list receiving e-mail
messages from the Switch. Up to 8 e-mail addresses can be
added per Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
51
To Next Page
Loading...
