DES-3000 Series Layer 2 Switch CLI Reference Manual
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>
Description MAC address notificiation is used to monitor MAC addresses learned and entered into
the FDB.
Parameters interval <sec 1-2147483647> - The time in seconds between notifications. The user may
choose an interval between 1 and 2,147,483,647 seconds.
historysize <1 - 500> - The maximum number of entries listed in the history log used for
notification.
Restrictions Only administrator-level users can issue this command.
Example usage: To configure the Switch’s MAC address table notification global settings:
DES-3026:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DES-3026:4#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist | all] [enable | disable]
Description MAC address notificiation is used to monitor MAC addresses learned and entered
into the FDB.
Parameters <portlist> - Specify a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC address table
notification on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage: To enable port 7 for MAC address table notification:
DES-3026:4#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DES-3026:4#
139
To Next Page
Loading...
