DES-3000 Series Layer 2 Switch CLI Reference Manual
Example usage:
To configure RADIUS settings:
DES-3026:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DES-3026:4#
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description The show radius command is used to display the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display RADIUS settings on the Switch:
DES-3026:4#
DES-3026:4#show radius
Command: show radius
Index IP Address Auth-Port Acct-Port Status Key
Number Number
----- ------------------ --------- --------- ----------- ------------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active des3226
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
create 802.1x user
Purpose Used to create a new 802.1x user.
Syntax
create 802.1x user <username 15>
Description
The create 802.1x user command is used to create new 802.1x
users.
Parameters
<username 15> − A username of up to 15 alphanumeric characters
in length.
Restrictions Only administrator-level users can issue this command.
177
To Next Page
Loading...
Need help?
General
