DES-3000 Series Layer 2 Switch CLI Reference Manual
config log_save_timing
Purpose Used to configure automatic saving of log to Syslog host.
Syntax
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
Description
The config log_save_timing command is used to configure the terms of saving
Switch logs to designated hosts.
Parameters
time_interval <min 1-65535> − Specifies the minimum interval between saves in
minutes.
on_demand – Specifies that logs are saved when requested by the host receiving the
log.
log_trigger – Specifies that logs are saved when previously configured triggers require
the log to be saved to the Syslog host. Use config syslog host command to determine
what triggers are used.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure log timing:
DES-3026:4#config log_save_timing log_trigger
Command: config log_save_timing log_trigger
Warning: If too many log information is produced, the flash may be worn
down soo
n!!!
Are you sure you want to proceed?(y/n)
Success
DES-3026:4#
72
To Next Page
Loading...
