DES-3000 Series Layer 2 Switch CLI Reference Manual
create cpu access_profile
ip − Specifies that the Switch will examine the IP address in each frame’s header.
• destination_ip_mask <netmask> − Specifies an IP address mask for the destination
IP address.
• type − Specifies that the Switch will examine each frame’s ICMP Type field.
• type − Specifies that the Switch will examine each frame’s IGMP Type field.
• vlan − Specifies a VLAN mask.
• source_ip_mask <netmask> − Specifies an IP address mask for the source IP
address.
• dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in
each frame’s header.
• icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field in each frame’s header.
• code − Specifies that the Switch will examine each frame’s ICMP Code field.
• igmp − Specifies that the Switch will examine each frame’s Internet Group
Management Protocol (IGMP) field.
• tcp − Specifies that the Switch will examine each frames Transport Control Protocol
(TCP) field.
• src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
• dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination
port.
• flag_mask [ all | {urg | ack | psh | rst | syn | fin}] – Enter the appropriate flag_mask
parameter. All incoming packets have TCP port numbers contained in them as the
forwarding criterion. These numbers have flag bits associated with them which are
parts of a packet that determine what to do with the packet. The user may deny
packets by denying certain flag bits within the packets. The user may choose
between all, urg (urgent), ack (acknowledgement), psh (push), rst (reset), syn
(synchronize) and fin (finish).
• udp − Specifies that the switch will examine each frame’s Universal Datagram
Protocol (UDP) field.
• src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port.
• dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination
port.
• protocol_id − Specifies that the Switch will examine each frame’s Protocol ID field.
• user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP
protocol ID and the mask options behind the IP header.
152
To Next Page
Loading...
