DES-3000 Series Layer 2 Switch CLI Reference Manual
config cpu access_profile
ip − Specifies that the Switch will look into the IP fields in each packet.
• vlan <vlan_name 32> − Specifies that the access profile will apply to only this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will apply to only packets with
this source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will apply to only packets
with this destination IP address.
• dscp <value 0-63> − Specifies that the access profile will apply only to packets that
have this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP
packet header
• icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to this ICMP
type value.
• code <value 0-255> − Specifies that the access profile will apply to this ICMP
code.
• igmp − Specifies that the Switch will examine the Internet Group Management
Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will apply to packets
that have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP source port in their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this TCP destination port in their TCP header.
• protocol_id <value 0-255> − Specifies that the switch will examine the Protocol field
in each packet and if this field contains the value entered here, apply the following
rules.
• udp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
field within each packet.
• src_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP source port in their header.
• dst_port <value 0-65535> − Specifies that the access profile will apply only to
packets that have this UDP destination port in their header.
• protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field
in each packet and if this field contains the value entered here, apply the following
rules.
• user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP
protocol ID and the mask options behind the IP header.
156
To Next Page
Loading...
