D-Link DES-3026 - Switch - create snmp user

DES-3000 Series Layer 2 Switch CLI Reference Manual
Command Parameters
auth_priv]] {read_view <view_name 32> | write_view
<view_name 32> | notify_view <view_name 32>}
delete snmp group <groupname 32>
show snmp groups
create snmp host <ipaddr> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]] <auth_string 32>
delete snmp host <ipaddr>
show snmp host {<ipaddr>}
enable rmon
disable rmon
create trusted_host <ipaddr>
delete trusted_host <ipaddr>
show trusted_host <ipaddr>
enable snmp traps
disable snmp traps
enable snmp
authenticate traps
disable snmp
authenticate traps
show snmp traps
config snmp
system_contact
<sw_contact>
config snmp
system_location
<sw_location>
config snmp
system_name
<sw_name>
Each command is listed, in detail, in the following sections.
create snmp user
Purpose Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
Syntax
create snmp user <SNMPname 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32>| sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
Description
The create snmp user command creates a new SNMP user and
adds the user to an SNMP group that is also created by this
command.
Parameters
<SNMPname 32> − An alphanumeric name of up to 32 characters
that will identify the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters
28