DES-3000 Series Layer 2 Switch CLI Reference Manual
show snmp host
Parameters
<ipaddr> − The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DES-3026:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------------- ------------------------------
10.48.76.23 V2c private
10.48.74.100 V3 public
Total Entries: 2
DES-3026:4#
enable rmon
Purpose Used to enable RMON on the Switch.
Syntax
enable rmon
Description
This command is used, in conjunction with the disable rmon
command below, to enable and disable remote monitoring (RMON)
on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable RMON:
DES-3026:4#enable rmon
Command: enable rmon
Success.
DES-3026:4#
disable rmon
Purpose Used to disable RMON on the Switch.
Syntax
disable rmon
Description
This command is used, in conjunction with the enable rmon
command above, to enable and disable remote monitoring (RMON)
42
To Next Page
Loading...
