D-Link DGS-3000 series - Page 89

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
85
offset_chunk_1 - (Optional) Specifies that the offset chunk 1 will be used.
<value 0-31> - Enter the offset chunk 1 value here. This value must be between 0 and 31.
<hex 0x0-0xffffffff> - Enter the offset chunk 1 mask here.
offset_chunk_2 - (Optional) Specifies that the offset chunk 2 will be used.
<value 0-31> - Enter the offset chunk 2 value here. This value must be between 0 and 31.
<hex 0x0-0xffffffff> - Enter the offset chunk 2 mask here.
offset_chunk_3 - (Optional) Specifies that the offset chunk 3 will be used.
<value 0-31> - Enter the offset chunk 3 value here. This value must be between 0 and 31.
<hex 0x0-0xffffffff> - Enter the offset chunk 3 mask here.
offset_chunk_4 - (Optional) Specifies that the offset chunk 4 will be used.
<value 0-31> - Enter the offset chunk 4 value here. This value must be between 0 and 31.
<hex 0x0-0xffffffff> - Enter the offset chunk 4 mask here.
ipv6 - Specifies this is the IPv6 mask.
class - (Optional) Specifies the IPv6 class.
flowlabel - (Optional) Specifies the IPv6 flow label.
source_ipv6_mask - (Optional) Specifies an IPv6 source sub-mask.
<ipv6mask> - Enter the source IPv6 mask value here.
destination_ipv6_mask - (Optional) Specifies an IPv6 destination sub-mask.
<ipv6mask> -Enter the destination IPv6 mask value here.
tcp - (Optional) Specifies that the rule applies to TCP traffic.
src_port_mask - (Optional) Specifies an IPv6 TCP source port mask.
<hex 0x0-0xffff> - Enter the TCP source port mask value here.
dst_port_mask - (Optional) Specifies an IPv6 TCP destination port mask.
<hex 0x0-0xffff> - Enter the TCP destination port mask value here.
udp - (Optional) Specifies that the rule applies to UDP traffic.
src_port_mask - Specifies the UDP source port mask.
<hex 0x0-0xffff> - Enter the UDP source port mask value here.
dst_port_mask - Specifies the UDP destination port mask.
<hex 0x0-0xffff> - Enter the UDP destination port mask value here.
icmp - (Optional) Specifies a mask for ICMP filtering.
type - (Optional) Specifies the inclusion of the ICMP type field in the mask.
code - (Optional) Specifies the inclusion of the ICMP code field in the mask.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create three access profiles: