D-Link DGS-3200 SERIES - Config Loopdetect Ports

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
230
Restriction
You must have administrator privileges.
Examples
To set a recover time of 0 and an interval of 20 in VLAN-based mode:
DGS-3200-10:4# config loopdetect recover_timer 0 interval 20 vlan-based
Command: config loopdetect recover_timer 0 interval 20 vlan-based
Success.
DGS-3200-10:4#
31-2 config loopdetect ports
Purpose
Used to configure loop-back detection function for the port on the switch.
Format
config loopdetect ports [<portlist>| all] state [enable | disable ]
Description
The config loopdetect port command is used to setup the loop-back detection function for the interface on
the switch.
Parameters
Parameters Description
portlist
all
Specifies a range of ports to be configured..
For set all ports in the system , you may use “all” parameter.
state
Allows loop-detect to be enabled or disabled for the ports specified
in the port list. The default is disabled.
Restriction
You must have administrator privileges.
Examples
To set state to enable: