D-Link DGS-3200 SERIES - Show Cpu Access_Profile

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
427
Specifies that the rule applies to the value of IP protocol ID
traffic.
protocod_id
user_define
Specifies the L4 part value.
offset_0-15
Specifies value for packet bytes 0-15.
offset_16-31
Specifies value for packet bytes 16-31.
offset_32-47
Specifies value for packet bytes 32-47.
offset_48-63
Specifies value for packet bytes 48-63.
packet_conten
t
offset_64-79
Specifies value for packet bytes 64-79.
class
Specifies IPv6 class value.
flowlabel
Specifies IPv6 flow label value.
source_ipv6
Specifies IPv6 source IP value.
destination_ip
v6
Specifies IPv6 destionation IP value.
permit
Specifies the packets that match the access profile are permitted by the switch.
deny
Specifies the packets that match the access profile are filtered by the switch.
time_range
Specifies name of this time range entry.
Restrictions
You must have administrator privileges.
Example
To configure access list entry:
DGS-3200-10:4#config cpu access_profile profile_id 1 add access_id 1 ethernet vl
an default port 1-3 deny
Command: config cpu access_profile profile_id 1 add access_id 1 ethernet vlan de
fault port 1-3 deny
Success.
DGS-3200-10:4#
46-10 show cpu access_profile
Purpose
Used to display current CPU access list table.