D-Link DGS-3200 SERIES - Enable Snmp Authenticate_Traps; Disable Snmp Authenticate_Traps

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
90
Example
To prevent SNMP traps from being sent from the switch:
DGS-3200-10:4#disable snmp traps
Command: disable snmp traps
Success.
DGS-3200-10:4#
7-12 enable snmp authenticate_traps
Purpose
Used to enable SNMP authentication failure trap support.
Format
enable snmp authenticate_traps
Description
The enable snmp authenticate_traps command enables SNMP authentication failure trap support.
Parameters
None.
Restrictions
You must have administrator privileges.
Example
To enable SNMP authentication trap support:
DGS-3200-10:4#enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
DGS-3200-10:4#
7-13 disable snmp authenticate_traps
Purpose
Used to disable SNMP authentication failure trap support.