DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
433
countdown, and time_interval as well.
threshold
The upper threshold at which the specified storm control will turn on.
The <value 512-1024000>is the number of broadcast/multicast
packets per second received by the switch that will trigger the storm
traffic control measure. Must be an unsigned integer.
countdown
Timer for shutdown mode. When a port enters a shutdown RX state,
and if this times out, the port will shut down the port forever. The
default is 0 minutes. 0 is the disable forever state.
time_interval
The sampling interval of received packet counts. The possible
value will be 5 to 30 seconds. This parameter is meaningless for
dropping packets is selected as action.
Restrictions
You must have administrator privileges.
Examples
To configure traffic control and state:
DGS-3200-10:4#config traffic control 1-10 broadcast enable action shutdown
threshold
1 time_interval 10
Command: config traffic control 1-
0 broadcast enable action shutdown threshold
1
10 time_interval 10
Success.
DGS-3200-10:4#
47-2 config traffic trap
Purpose
Used to configure a traffic control trap.
Format
config traffic trap [none|storm_occurred|storm_cleared|both]
Description
This command configures whethers storm control notification will be generated or not while traffic
To Next Page
Loading...
