D-Link DGS-3200 SERIES - Show Access_Profile

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
418
flowlabel
Specifies IPv6 flow label value.
source_ipv6
Specifies IPv6 source IP value.
destination_ip
v6
Specifies IPv6 destionation IP value.
permit
Specifies the packets that match the access profile are permit by the switch.
priority
Specifies the packets that match the access profile are remap the 802.1p priority
tag field by the switch.
replace_priorit
y
Specifies the packets that match the access profile remarking the 802.1p priority
tag field by the switch.
rx_rate
Specifies the limitation of receive data rate.
replace_dscp
Specifies the DSCP of the packets that match the access profile are modified
according to the value.
deny
Specifies the packets that match the access profile are filtered by the switch.
time_range
Specifies name of this time range entry.
Restrictions
You must have administrator privileges.
Example
To configure an access list entry:
DGS-3200-10:4#config access_profile profile_id 101 add access_id 1 ip vlan defau
lt source_ip 20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp port 1 permit
Command: config access_profile profile_id 101 add access_id 1 ip vlan default so
urce_ip 20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp port 1 permit
Success.
DGS-3200-10:4#
46-4 show access_profile
Purpose
Used to display current access list table.
Format
show access_profile {profile_id <value 1-200>}