D-Link DGS-3200 SERIES - Config 802.1 X Reauth

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
275
Format
config 802.1x init [port_based ports [<portlist|all>] |mac_based ports [<portlist>|all] {mac_address
<macaddr>}]
Description
The config 802.1x init command used to initialize the authentication state machine of some or all.
Parameters
Parameters Description
port_based
Configure the authentication as port-based mode.
mac_based
Configure the authentication as MAC-based mode.
portlist
Specifies a range of ports to be configured.
all
All ports.
mac_address
MAC address of the client.
.
Restrictions
You must have administrator privileges.
Examples
To initialize the authentication state machine of some or all.:
DGS-3200-10:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3200-10:4#
35-12 config 802.1x reauth
Purpose
Used to reauthenticate the device connected with the port.
Format
config 802.1x reauth [port_based ports [<portlist|all>] |mac_based ports [<portlist>|all]
{mac_address <macaddr>}]
Description
The config 802.1x reauth command reauthenticates the device connected with the port. During the
reauthentication period, the port status remains authorized until failed reauthentication.