D-Link DGS-3200 SERIES - Page 426

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
426
offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>|
offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> }
| ipv6
{class <value 0-255> | flowlabel <hex 0x0-0xfffff>|
source_ipv6 <ipv6addr> | destination_ipv6 <ipv6addr>} ]
port [<portlist> | all ] [ permit | deny] {time_range <range_name 32>}
| delete access_id <value 1-100> ]
Description
The config cpu access_profile command configures CPU access list entry.
Parameters
Parameters Description
profile_id
Specifies the index of CPU access list profile.
Specifies the index of an access list entry. The range of this value is 1 to 100.
vlan
Specifies a VLAN name.
source_mac
Specifies the source MAC.
destination_m
ac
Specifies the destination MAC.
802.1p
Specifies the value of 802.1p priority tag, the value can be
configured between 1 and 7.
ethernet_type
Specifies the Ethernet type.
vlan
Spcifies a VLAN name.
source_ip
Specifies an IP source address.
destination_ip
Specifies an IP destination address.
dscp
Specifies the value of DSCP, the value can be configured from
0 to 63.
Specifies that the rule applies to ICMP traffic.
type
Specifies the ICMP packet type.
icmp
code
Specifies the ICMP packet code.
Specifies that the rule applies to IGMP traffic.
igmp
type
Specifies the IGMP packet type.
src_port
Specifies that the rule applies to the range of TCP
source ports.
dst_port
Specifies the range of the TCP destination port range
tcp
flag
Specifies the TCP flag fields.
src_port
Specifies the range of the TCP source port range.
access_id
udp
dst_port
Specifies the range of the TCP destination port mask