D-Link DGS-3200 SERIES - Connecting the Switch; Switch to End Node; Switch to Switch

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
26
Format
show ports {<portlist>} { [ description | err_disabled] }
Description
The show ports command displays the current configurations of a range of ports. No parameter will show
all ports.
Parameters
Parameters Description
portlist
Specified a range of ports to be displayed.
description
Indicate if port description will be included in the display .
err-disabled
Indicate if ports are disabled by some reasons will be displayed.
Note: If no parameter is specified, all ports will be displayed.
Restrictions
None.
Example
To display the configuration of ports 1-4
DGS-3200-10:4#show ports 1-4
Command: show ports 1-4
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
1 Enabled 10M/Full/Enabled Err-Disabled Enabled
2 Enabled 10M/Full/Enabled Link Down Enabled
3 Enabled 10M/Full/Enabled Err-Disabled Enabled
4 Enabled Auto/Disabled Link Down Enabled
DGS-3200-10:4#
DGS-3200-10:4#show ports 1-4 description
Command: show ports 1-4 description
Port Port Settings Connection status Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------