D-Link DWS-3000 Series

LLDP (802.1AB) Commands 107
2 Switching Commands
Use port-desc to transmit the port description TLV. To configure the port description, see See
“description” on page 38.
Default no optional TLVs are included
Format
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Format.
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
Format
lldp transmit-mgmt
Mode Interface Config
no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the management
information in LLDPDUs.
Format
no lldp transmit-mgmt
Mode Interface Config
lldp notification
Use this command to enable remote data change notifications.
Default disabled
Format
lldp notification
Mode Interface Config
no lldp notification
Use this command to disable notifications.
Default disabled
Format
no lldp notification
Mode Interface Config