126 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
show ip interface
This command displays all pertinent information about the IP interface.
Format
show ip interface <slot/port>
Modes Privileged EXEC
User EXEC
Primary IP Address The primary IP address and subnet masks for the interface. This value
appears only if you configure it.
Secondary IP Address One or more secondary IP addresses and subnet masks for the inter-
face. This value appears only if you configure it.
Routing Mode The administrative mode of router interface participation. The possible values
are enable or disable. This value is configurable.
Administrative Mode The administrative mode of the specified interface. The possible val-
ues of this field are enable or disable. This value is configurable.
Routing Configuration Displays whether Routing Configuration is enabled or disabled on
the system.
Interface Configuration Status Displays whether the Interface Configuration is enabled or
disabled on the system.
Forward Net Directed Broadcasts Displays whether forwarding of network-directed
broadcasts is enabled or disabled. This value is configurable.
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the inter-
face.
Active State Displays whether the interface is active or inactive. An interface is considered
active if its link is up and it is in forwarding state.
Link Speed Data Rate An integer representing the physical link data rate of the specified
interface. This is measured in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-
digit hexadecimal numbers that are separated by colons.
Encapsulation Type The encapsulation type for the specified interface. The types are: Ether-
net or SNAP.
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
To Next Page
Loading...
Need help?
General
