198 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
MAC Address The Ethernet address of the AP.
IP Address The network IP address of the AP.
Last Failure Type Indicates the last type of failure that occurred.
Validation Failure Count The count of association failures for this AP.
Authentication Failure Count The count of authentication failures for this AP.
Vendor ID Vendor of the AP software.
Protocol Version Indicates the protocol version supported by the software on the AP.
Software Version Indicates the version of software on the AP.
Hardware Type Hardware platform for the AP.
Age Time in seconds since failure occurred.
RF Scan Access Point Status Commands
The commands in this section provide views and management of data maintained for all
access points known by the Unified Switch via RF scan data obtained from the managed
access points.
clear wireless ap rf-scan list
This command deletes all entries from the RF scan list; entries normally age out according to
the configured age time.
Format
clear wireless ap rf-scan list
Mode Privileged EXEC
show wireless ap rf-scan status
This command displays summary or detailed data for APs detected via RF scan on the
managed APs. If the optional MAC address parameter is specified, detailed data is displayed.
Format
show wireless ap [<macaddr>] rf-scan status
Mode Privileged EXEC
macaddr AP MAC address detected in RF scan.
MAC Address The Ethernet MAC address of the detected AP, this could be a physical radio
interface or VAP MAC. For D-Link APs, this is always a VAP MAC address.
SSID Service Set ID of the network, this is broadcast in detected beacon frame.
Physical Mode Indicates the 802.11 mode being used on the AP.
Channel Transmit channel of the AP.
Transmit Rate Indicates the rate at which the AP is currently transmitting data.
Beacon Period Beacon interval for the neighbor AP network.
To Next Page
Loading...
