D-Link DWS-3000 Series

136 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format no bootpdhcprelay enable
Mode Global Config
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay
on the system. The
<hops> parameter has a range of 1 to 16.
Default 4
Format
bootpdhcprelay maxhopcount <1-16>
Mode Global Config
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP
Relay on the system.
Format
no bootpdhcprelay maxhopcount
Mode Global Config
bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the
system. When the BOOTP relay agent receives a BOOTREQUEST message, it MAY use the
seconds-since-client-began-booting field of the request as a factor in deciding whether to relay
the request or not. The parameter has a range of 0 to 100 seconds.
Default 0
Format
bootpdhcprelay minwaittime <0-100>
Mode Global Config
no bootpdhcprelay minwaittime
This command configures the default minimum wait time in seconds for BootP/DHCP Relay
on the system.
Format
no bootpdhcprelay minwaittime
Mode Global Config
bootpdhcprelay serverip
This command configures the server IP address for BootP/DHCP Relay on the system. The
<ipaddr> parameter is an IP address in a 4-digit dotted decimal format.
Default 0.0.0.0
Format
bootpdhcprelay serverip <ipaddr>
Mode Global Config