D-Link DWS-3000 Series

Port Mirroring 93
2 Switching Commands
show port-channel
This command displays an overview of all port-channels (LAGs) on the switch.
Format
show port-channel {<logical slot/port> | all}
Modes Privileged EXEC
User EXEC
Logical Interface Valid slot and port number separated by forward slashes.
Port-Channel Name The name of this port-channel (LAG). You may enter any string of up
to 15 alphanumeric characters.
Link State Indicates whether the Link is up or down.
Admin Mode May be enabled or disabled. The factory default is enabled.
Mbr Ports A listing of the ports that are members of this port-channel (LAG), in slot/port
notation. There can be a maximum of eight ports assigned to a given port-
channel (LAG).
Device Timeout For each port, lists the timeout (long or short) for Device Type (actor or
partner)
Port Speed Speed of the port-channel port.
Type The status designating whether a particular port-channel (LAG) is statically or
dynamically maintained.
Static - The port-channel is statically maintained.
Dynamic - The port-channel is dynamically maintained.
Active Ports This field lists ports that are actively participating in the port-channel (LAG).
Port Mirroring
Port mirroring, which is also known as port monitoring, selects network traffic that you can
analyze with a network analyzer, such as a SwitchProbe device or other Remote Monitoring
(RMON) probe.
monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). Use the
source interface <slot/port> parameter to specify the interface to
monitor. Use
rx to monitor only ingress packets, or use tx to monitor only egress packets. If
you do not specify an
{rx | tx} option, the destination port monitors both ingress and egress
packets. Use the
destination interface <slot/port> to specify the interface to receive
the monitored traffic. Use the
mode parameter to enabled the administrative mode of the
session. If enabled, the probe port monitors all the traffic received and transmitted on the
physical monitored port.
Format
monitor session <session-id> {source interface <slot/port> [{rx
| tx}] | destination interface <slot/port> | mode}
Mode Global Config