D-Link DWS-3000 Series

320 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
no radius server msgauth <ipaddr>
Mode Global Config
radius server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining configured
servers are only used if the primary server cannot be reached. You can configure up to three
servers on each client. Only one of these servers can be configured as the primary. If a primary
server is already configured prior to this command being executed, the server specified by the
IP address specified used in this command will become the new primary server. The IP address
must match that of a previously configured RADIUS authentication server.
Format
radius server primary <ipaddr>
Mode Global Config
radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted when no
response is received from the RADIUS server. The retries value is an integer in the range of 1
to 15.
Default 4
Format
radius server retransmit <retries>
Mode Global Config
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to the
default value.
Format
no radius server retransmit
Mode Global Config
radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted
to the RADIUS server if no response is received. The timeout value is an integer in the range
of 1 to 30.
Default 5
Format
radius server timeout <seconds>
Mode Global Config