D-Link DWS-3000 Series

Logging Commands 271
6 Utility Commands
Format no logging syslog
Mode Global Config
show logging
This command displays logging configuration information.
Format
show logging
Mode Privileged EXEC
Logging Client Local Port Port on the collector/relay to which syslog messages are sent.
CLI Command Logging Shows whether CLI Command logging is enabled.
Console Logging Shows whether console logging is enabled.
Console Logging Severity Filter The minimum severity to log to the console log. Messages
with an equal or lower numerical severity are logged.
Buffered Logging Shows whether buffered logging is enabled.
Syslog Logging Shows whether syslog logging is enabled.
Log Messages Received Number of messages received by the log process. This includes
messages that are dropped or ignored.
Log Messages Dropped Number of messages that could not be processed due to error or lack
of resources.
Log Messages Relayed Number of messages sent to the collector/relay.
show logging buffered
This command displays buffered logging (system startup and system operation logs).
Format
show logging buffered
Mode Privileged EXEC
Buffered (In-Memory) Logging Shows whether the In-Memory log is enabled or disabled.
Buffered Logging Wrapping Behavior The behavior of the In Memory log when faced with
a log full situation.
Buffered Log Count The count of valid entries in the buffered log.
show logging hosts
This command displays all configured logging hosts.
Format
show logging hosts
Mode Privileged EXEC
Host Index (Used for deleting hosts)
IP Address IP address of the logging host.
Severity Level The minimum severity to log to the specified address. The possible values are
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6),
or debug (7).