D-Link DWS-3000 Series

DHCP and BOOTP Relay Commands 135
3 Routing Commands
show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format
show ip vrrp interface brief
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the switch.
A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between
clients and servers when they are not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode Global Config
bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
Default disabled
Format
bootpdhcprelay enable
Mode Global Config
no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the
system.