D-Link DWS-3000 Series

300 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode Line Config
session-limit
This command specifies the maximum number of simultaneous outbound Telnet sessions. A
value of 0 indicates that no outbound Telnet session can be established.
Default 5
Format
session-limit <0-5>
Mode Line Config
no session-limit
This command sets the maximum number of simultaneous outbound Telnet sessions to the
default value.
Format
no session-limit
Mode Line Config
session-timeout
This command sets the Telnet session timeout value.The timeout value unit of time is minutes.
Default 5
Format
session-timeout <1-160>
Mode Line Config
no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value unit of
time is minutes.
Format
no session-timeout
Mode Line Config
telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can be
established. A value of 0 indicates that no Telnet connection can be established. The range is
0-5.
Default 5
Format
telnetcon maxsessions <0-5>
Mode Privileged EXEC