Client Failure and Ad Hoc Status Commands 203
4 Wireless Commands
Mode Privileged EXEC
show wireless client failure status
This command displays the client failure status parameters.
Format
show wireless client [<macaddr>] failure status
Mode Privileged EXEC
macaddr Client MAC address.
MAC Address The Ethernet address of the client.
VAP MAC Address The managed AP VAP Ethernet MAC address on which the client
attempted to associate and/or authenticate.
SSID The network SSID on which the client attempted to associate and/or authenti-
cate.
Last Failure Type Indicates the last type of failure that occurred.
Authentication Failure Count Count of authentication failures for this client.
Association Failure Count Count of association failures for this client.
Age Time since failure occurred.
show wireless client adhoc status
This command displays summary or detailed data for Ad Hoc clients detected on the network
by a managed AP.
Format
show wireless client [<macaddr>] adhoc status
Mode Privileged EXEC
macaddr Client MAC address.
MAC Address The Ethernet address of the client. If the Detection Mode is Beacon, then the
client is represented as an AP in the RF Scan database and the Neighbor AP
List. If the Detection Mode is Data Frame, then the client information is in the
Neighbor Client List.
AP MAC Address The base Ethernet MAC Address of the managed AP which detected the
client.
Location The configured descriptive location for the managed AP.
Radio The radio interface on the AP that detected the ad hoc device.
Detection Mode The mechanism of detecting this Ad Hoc device. The possible values are
Beacon Frame or Data Frame.
Age Time in seconds since the last detection of the ad hoc network.
To Next Page
Loading...
Need help?
General
