D-Link DWS-3000 Series

Spanning Tree Protocol (STP) Commands 43
2 Switching Commands
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value.
Format
no spanning-tree configuration revision
Mode Global Config
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Format
spanning-tree edgeport
Mode Interface Config
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
no spanning-tree edgeport
Mode Interface Config
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. Use 802.1d to
specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d
functionality supported). Use 802.1w to specify that the switch transmits RST BPDUs rather
than MST BPDUs (IEEE 802.1w functionality supported). Use 802.1s to specify that the
switch transmits MST BPDUs (IEEE 802.1s functionality supported).
Default 802.1s
Format
spanning-tree forceversion <802.1d | 802.1s | 802.1w>
Mode Global Config
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Format
no spanning-tree forceversion
Mode Global Config
spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the common and
internal spanning tree. The forward-time value is in seconds within a range of 4 to 30, with the
value being greater than or equal to “(Bridge Max Age / 2) + 1”.
Default 15