D-Link DWS-3000 Series

Storm-Control Commands 85
2 Switching Commands
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control multicast level <0-100>
Mode Interface Config
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an interface
and disables multicast storm recovery.
Format
no storm-control multicast level
Mode Interface Config
storm-control multicast all
This command enables multicast storm recovery mode for all interfaces. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast all
Mode Global Config
no storm-control multicast all
This command disables multicast storm recovery mode for all interfaces.
Format
no storm-control multicast all
Mode Global Config
storm-control multicast all level
This command configures the multicast storm recovery threshold, in terms of percentage of
the interface speed, for all interfaces and enables multicast storm recovery mode. If the mode
is enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing
on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of multicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control multicast all level <0-100>
Mode Global Config