DHCP Server Commands 283
6 Utility Commands
Default ethernet
Format
hardware-address <hardwareaddress> <type>
Mode DHCP Pool Config
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
host
This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32
Default none
Format
host <address> [{<mask> | <prefix-length>}]
Mode DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode DHCP Pool Config
lease
This command configures the duration of the lease for an IP address that is assigned from a
DHCP server to a DHCP client. The overall lease time should be between 1-86400 minutes. If
you specify
infinite, the lease is set for 60 days. You can also specify a lease duration. Days
is an integer from 0 to 59.
Hours is an integer from 0 to 1439. Minutes is an integer from 0 to
86399.
Default 1 (day)
Format
lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode DHCP Pool Config
no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode DHCP Pool Config
To Next Page
Loading...
