D-Link DWS-3000 Series

90 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However
if the maximum number of allowable dynamic port-channels are already present in the system,
the static mode for a new port-channel enabled, which means the port-channel is static.You
can only use this command on port-channel interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode Interface Config
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default enabled
Format port lacpmode
Mode Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format
no port lacpmode
Mode Interface Config
port lacpmode all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format
port lacpmode all
Mode Global Config
no port lacpmode all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format
no port lacpmode all
Mode Global Config