D-Link DWS-3000 Series

Double VLAN Commands 63
2 Switching Commands
Metro Core in a simple and cost effective manner. The additional tag on the traffic helps
differentiate between customers in the MAN while preserving the VLAN identification of the
individual customers when they enter their own 802.1Q domain.
dvlan-tunnel ethertype
This command configures the ether-type for all interfaces. The ether-type may have the values
of
802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional value of the
custom ether type must be set to a value from 0 to 65535.
Default vman
Format
dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]
Mode Global Config
mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
Default disabled
Format
mode dot1q-tunnel
Mode Interface Config
no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
Format
no mode dot1q-tunnel
Mode Interface Config
mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
NOTE: When you use the mode dvlan-tunnel command on an interface, it becomes
a service provider port. Ports that do not have double VLAN tunneling
enabled are customer ports.
Default disabled
Format
mode dvlan-tunnel
Mode Interface Config
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
Format
no mode dvlan-tunnel
Mode Interface Config