D-Link DWS-3000 Series

Port-Based Network Access Control Commands 77
2 Switching Commands
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled,
the dot1x configuration is retained and can be changed, but is not activated.
Default disabled
Format
dot1x system-auth-control
Mode Global Config
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format.
no dot1x system-auth-control
Mode Global Config
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine
on this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported:
• reauth-period — The value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place.
The reauth-period must be a value in the range 1 - 65535.
• quiet-period — The value, in seconds, of the timer used by the authenticator state
machine on this port to define periods of time in which it will not attempt to acquire a sup-
plicant. The quiet-period must be a value in the range 0 - 65535.
• tx-period — The value, in seconds, of the timer used by the authenticator state machine
on this port to determine when to send an EAPOL EAP Request/Identity frame to the sup-
plicant. The quiet-period must be a value in the range 1 - 65535.
• supp-timeout — The value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supp-timeout must be a value in the
range 1 - 65535.
• server-timeout — The value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the authentication server. The supp-timeout must be a
value in the range 1 - 65535.
Default reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
Format
dot1x timeout {{reauth-period <seconds>} | {quiet-period <sec-
onds>} | {tx-period <seconds>} | {supp-timeout <seconds>} |
{server-timeout <seconds>}}
Mode Interface Config