D-Link DWS-3000 Series

Wireless Network Commands 165
4 Wireless Commands
Format wpa2 pre-authentication timeout <0-1440>
Mode Network Config
0-1440 The WPA2 pre-authentication timeout in minutes, where 0 indicates pre-
authentications do not timeout on the AP.
no wpa2 pre-authentication timeout
The no version of this command sets the WPA2 pre-authentication timeout to its default value.
Format
no wpa2 pre-authentication timeout
Mode Network Config
wpa2 pre-authentication limit
This command configures the WPA2 pre-authentication limit for the network. This specifies a
limit on the number of APs within the peer group to which one client is allowed to pre-
authenticate.
Default 0, no limit
Format
wpa2 pre-authentication limit <0-192>
Mode Network Config
0-192
Valid WPA2 pre-authentication limit
no wpa2 pre-authentication limit
The no version of this command sets the configured WPA2 pre-authentication limit to its
default value.
Format
no wpa2 pre-authentication limit
Mode Network Config
wpa2 key-forwarding
This command enables WPA2 key forwarding support for client roaming on the network.
Default Enable
Format
wpa2 key-forwarding
Mode Network Config
no wpa2 key-forwarding
The no version of this command disables WPA2 key forwarding support on the network.
Format
no wpa2 key-forwarding
Mode Network Config