D-Link DWS-3000 Series

228 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format classofservice dot1p-mapping <userpriority> <trafficclass>
Modes Global Config
Interface Config
no classofservice dot1p-mapping
This command maps each 802.1p priority to its default internal traffic class value.
Format
no classofservice dot1p-mapping
Modes Global Config
Interface Config
classofservice ip-dscp-mapping
This command maps an IP DSCP value to an internal traffic class. The <ipdscp> value is
specified as either an integer from 0 to 63, or symbolically through one of the following
keywords:
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5,
cs6, cs7, ef.
The
<trafficclass> values can range from 0-6, although the actual number of available
traffic classes depends on the platform.
Format
classofservice ip-dscp-mapping <ipdscp> <trafficclass>
Mode Global Config
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
Format
no classofservice ip-dscp-mapping
Mode Global Config
classofservice trust
This command sets the class of service trust mode of an interface. You can set the mode to
trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set
the interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not
appear in the output of the
show running config command because Dot1p is the default.
NOTE: The classofservice trust dot1p command will not be supported in future
releases of the software because Dot1p is the default value. Use the
no clas-
sofservice trust command to set the mode to the default value.
Default dot1p
Format
classofservice trust {dot1p | ip-dscp | ip-precedence |
untrusted}
Mode Global Config
Interface Config