D-Link DWS-3000 Series

118 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no arp
This command deletes an ARP entry. The value for <arpentry> is the IP address of the
interface. The value for
<ipaddress> is the IP address of a device on a subnet attached to an
existing routing interface.
<macaddr> is a unicast MAC address for that device.
Format
no arp <ipaddress> <macaddr>
Mode Global Config
ip proxy-arp
This command enables proxy ARP on a router interface. Without proxy ARP, a device only
responds to an ARP request if the target IP address is an address configured on the interface
where the ARP request arrived. With proxy ARP, the device may also respond if the target IP
address is reachable. The device only responds if all next hops in its route to the destination are
through interfaces other than the interface that received the ARP request.
Default enabled
Format
ip proxy-arp
Mode Interface Config
no ip proxy-arp
This command disables proxy ARP on a router interface.
Format
no ip proxy-arp
Mode Interface Config
arp cachesize
This command configures the ARP cache size. The ARP cache size value is a platform
specific integer value. The default size also varies depending on the platform.
Format
arp cachesize <platform specific integer value>
Mode Global Config
no arp cachesize
This command configures the default ARP cache size.
Format
no arp cachesize
Mode Global Config
arp dynamicrenew
This command enables the ARP component to automatically renew dynamic ARP entries
when they age out.
Default enabled
Format
arp dynamicrenew
Mode Privileged EXEC