D-Link DWS-3000 Series

Port-Based Network Access Control Commands 75
2 Switching Commands
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Format
dot1x initialize <slot/port>
Mode Privileged EXEC
dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x
port security. The
<user> parameter must be a configured user and the <listname> parameter
must be a configured authentication login list.
Format
dot1x login <user> <listname>
Mode Global Config
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port
will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The
<count> value must be in the range 1 - 10.
Default 2
Format
dot1x max-req <count>
Mode Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port
will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
Format
no dot1x max-req
Mode Interface Config
dot1x port-control
This command sets the authentication mode to use on the specified port. Select force-
unauthorized to specify that the authenticator PAE unconditionally sets the controlled port to
unauthorized. Select
force-authorized to specify that the authenticator PAE unconditionally
sets the controlled port to authorized. Select
auto to specify that the authenticator PAE sets the
controlled port mode to reflect the outcome of the authentication exchanges between the
supplicant, authenticator and the authentication server.
Default auto
Format
dot1x port-control {force-unauthorized | force-authorized |
auto}
Mode Interface Config