164 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no tunnel
The no version of this command disables client traffic tunneling on the network.
Format
no tunnel
Mode Network Config
tunnel subnet
This command configures the tunnel subnet IP address for the network. This must match a
configured routing interface in order for the tunnel to be operational.
Default Subnet IP - None
Subnet mask - 255.255.255.0
Format
tunnel subnet <ipaddr> [mask <mask>]
Mode Network Config
ipaddr A valid IP address
mask A valid subnet mask
no tunnel subnet
The no version of this command deletes the configured tunnel subnet parameters.
Format
no tunnel subnet
Mode Network Config
wpa2 pre-authentication
This command enables WPA2 pre-authentication support for client roaming.
Default Enable
Format
wpa2 pre-authentication
Mode Network Config
no wpa2 pre-authentication
The no version of this command disables WPA2 pre-authentication support.
Format
no wpa2 pre-authentication
Mode Network Config
wpa2 pre-authentication timeout
This command configures the WPA2 pre-authentication timeout for the network. This
specifies a timeout after which an AP can delete a pre-authentication that has not been used by
the client.
Default 0, no timeout
To Next Page
Loading...
