274 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format enable passwd
Mode User EXEC
logout
This command closes the current telnet connection or resets the current serial connection.
NOTE: Save configuration changes before logging out.
Format
logout
Modes Privileged EXEC
User EXEC
ping
This command checks if another computer is on the network and listens for connections. To
use this command, configure the switch for network (in-band) connection. The source and
target devices must have the ping utility enabled and running on top of TCP/IP. You can ping
the switch from any IP workstation the switch is connected to through the default VLAN
(VLAN 1), as long as there is a physical path between the switch and the workstation. The
terminal interface sends three pings to the target station.
Format
ping <ipaddr>
Modes Privileged EXEC
User EXEC
quit
This command closes the current telnet connection or resets the current serial connection. The
system asks you whether to save configuration changes before quitting.
Format
quit
Modes Privileged EXEC
User EXEC
reload
This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. The LEDs on the switch indicate a successful reset.
Format
reload
Mode Privileged EXEC
To Next Page
Loading...
