D-Link DWS-3000 Series

142 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no discovery ip-list
The no version of this command deletes the specified IP address from the polling list. If an
argument is not specified, all entries are deleted from the polling list.
Format
no discovery ip-list [<ipaddr>]
Mode Wireless Config
discovery vlan-list
This command adds VLAN IDs on which to send L2 discovery multicast frames. Up to 16
VLAN IDs can be configured. By default, there is one entry in the list, 1 - Default VLAN.
Default 1 – Default VLAN
Format
discovery vlan-list <1-4094>
Mode Wireless Config
1-4094 A VLAN ID in the range 1 to 4094.
no discovery vlan-list
The no version of this command deletes the VLAN ID from the discovery list. If no arguments
are specified, all VLANs are deleted from the list except for the first entry. At least one entry
must be configured in the list.
Format
no discovery vlan-list [<1-4094>]
Mode Wireless Config
ap validation
This command configures whether to use the local valid AP database or a RADIUS server to
validate newly discovered APs.
Default local
Format
ap validation {local | radius}
Mode Wireless Config
local Local database is used for validating discovered APs.
radius RADIUS server is used for validating discovered APs.
ap authentication
This command enables AP authentication. When enabled, all APs are required to authenticate
to the Unified Switch using a password upon discovery.
Default Disable
Format
ap authentication
Mode Wireless Config