Unified Switch Channel and Power Commands 149
4 Wireless Commands
Ad Hoc Client Status Age (hours) Shows how long to continue to display an ad hoc client in
the status list since it was last detected.
AP Failure Status Age (hours) Shows how long to continue to display a failed AP in the sta-
tus list since it was last detected.
Client Failure Status Age (hours) Shows how long to continue to display a failed client in
the status list since it was last detected.
RF Scan Status Age (hours) Shows how long to continue to display an AP detected through
the RF Scan since it was last detected.
show wireless tunnel-mtu
Use this command to show the Tunnel MTU value. The value is expressed in bytes.
Format
show wireless tunnel-mtu
Mode Privileged EXEC
Example:
show wireless tunnel-mtu
(DWS-3024) #show wireless tunnel-mtu
tunnel-mtu..................................... 1500
clear wireless statistics
This clear command resets the global Unified Switch statistics.
Format
clear wireless statistics
Mode Privileged EXEC
Unified Switch Channel and Power Commands
The commands in this section provide status and configuration for automatic channel planning
and power adjustment.
channel-plan mode
This command configures the channel plan mode for each 802.11a and 802.11b/g frequency
band. If it is <interval>, a channel plan is computed and applied at every defined interval. If it
is <manual>, you must start and apply the channel plan manually. If it is <time>, then the
channel plan will be computed and applied at the scheduled time.
Default manual
Format
channel-plan {a | bg} mode {interval | manual | time}
Mode Wireless Config
a Configure channel plan mode for 802.11a.
To Next Page
Loading...
Need help?
General
