D-Link DWS-3000 Series

Virtual LAN Routing Commands 129
3 Routing Commands
User EXEC
Local The local route preference value.
Static The static route preference value.
OSPF Intra The OSPF Intra route preference value.
OSPF Inter The OSPF Inter route preference value.
OSPF Ext T1 The OSPF External Type-1 route preference value.
OSPF Ext T2 The OSPF External Type-2 route preference value.
OSPF NSSA T1 The OSPF NSSA Type-1 route preference value.
OSPF NSSA T2 The OSPF NSSA Type-2 route preference value.
RIP The RIP route preference value.
BGP4 The BGP-4 route preference value.
NOTE: The configuration of NSSA preferences is not supported in this release.
show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more information
about the fields that are displayed.
Format
show ip stats
Modes Privileged EXEC
User EXEC
Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to
view VLAN routing status information.
vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 3965.
Format
vlan routing <vlanid>
Mode VLAN Config
no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 3965.
Format
no vlan routing <vlanid>
Mode VLAN Config
show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.