Local Access Point Database Commands 155
4 Wireless Commands
show wireless peer-switch
This command displays status information for peer Unified Switches. If no parameters are
entered, the command will display summary status for all peer switches. If a peer switch IP
address is entered, detailed status for that peer switch is displayed.
Format
show wireless peer-switch [<ipaddr>]
Mode Privileged EXEC
ipaddr The <ipaddr> is a valid IP address.
IP Address IP address of the peer switch.
Vendor ID The peer switch software vendor ID.
Software Version Version of switch software on the peer switch.
Protocol Version Protocol version of switch software on the peer switch.
Discovery Reason Method for peer switch discovery.
Age Time since last update was received from the switch.
Local Access Point Database Commands
The commands in this section provide configuration of the local valid AP database. These
configurations may also be performed on an external RADIUS server.
ap database
This command adds an AP to the local valid AP database (if not already present) and enters
the AP configuration mode identified by the AP MAC address. In AP configuration mode,
you can configure parameters for each individual valid AP. Note that if a valid AP is already
being managed by the switch, you need to reset the AP to pick up any configuration changes in
the valid AP database. The valid AP database parameters are read only when the AP is
validated during discovery.
Format
ap database <macaddr>
Mode Wireless Config
macaddr MAC address of a physical AP.
no ap database
The no version of this command deletes the AP from the local database.
Format
no ap database <macaddr>
Mode Wireless Config
To Next Page
Loading...
Need help?
General
